Black & Decker NLP1800 Manual de Instruções Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 13
14
Troubleshooting Section
If your Chain Saw does not operate correctly check the following:
Problem
Possible Cause Possible Solution
Tool will not
start.
Unit will not
charge.
Bar / chain
overheated.
Battery not
installed properly.
Battery not
charged.
Battery not
inserted into
charger.
Chain too tight.
Lubrication
needed.
Check battery installation.
Check battery charging
requirements.
Insert battery into charger
until green LED appears.
Charge up to 9 hours if
battery totally drained.
Refer to “adjusting chain
tension” section.
Refer to “chain oiling”
section.
Chain is loose.
Poor cut
quality.
Chain tension set
incorrectly.
Chain tension set
incorrectly.
Chain needs
replacement.
Refer to “adjusting chain
tension” section.
Refer to “adjusting chain
tension” section.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain. Lubricate before
each cut.
Refer to “replacing the
chainsection.
Unit runs but
does not cut.
Chain installed
backwards.
Refer to sections for
installing and removing
chain.
Oil is not
getting to
chain.
Sawdust / debris is
accumulated under
sprocket cover.
Remove battery, remove
sprocket cover. Clean out
accumulated sawdust / debris.
See ‘Tools-
Electric’
– Yellow Pages –
for Service &
Sales
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-544-6986 for a free
replacement.
LATIN AMERICA: This warranty does not apply to products sold in
Latin America. For products sold in Latin America, check country
specific warranty information contained in the packaging, call the
local company or see the website for warranty information.
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Comentários a estes Manuais

Sem comentários