12
Switching on and off (fig. C)
◆ To switch the tool on, set the on/off switch (1)
to position I.
◆ To switch the tool off, set the on/off switch to
position O.
Hints for optimum use
◆ Shred dry materials last, as this will help to
clear moist material from the shredder.
◆ Do not allow material to pile up and compost
prior to shredding.
◆ You may feed shreddings into the shredder for
a second time to further reduce their volume.
◆ Refer to the chart at the end of this text.
MAINTENANCE
Your Black & Decker tool has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
Before performing any maintenance,
switch off and unplug the tool.
◆ After use, open the chute as described below.
Clean and dry the casing and the blade area.
Avoid the blades.
◆ Store the tool in a dry place, out of children’s
reach.
◆ Regularly check that the blades are sharp.
Replacement blades are available from
Black & Decker repair agents (cat. no. A6206).
To replace blades, proceed as instructed below.
Removing the chute (fig. D1 & D2)
You will need to remove the chute to obtain
access to the blade area.
Make sure that the tool is switched off and
unplugged.
◆ Loosen the thumb nut (7).
◆ Tilt the chute (3) backover (A), slide it forward (B)
and lift it upward (C).
◆ To replace the chute, proceed in reverse order.
Replacing the blades (fig. D1 - D4)
The blades can be used on both sides. When one
side has become blunt, you may use the other side.
◆ Make sure that the tool is switched off
and unplugged.
◆ Take care not to cut yourself.
Preferably wear gloves.
Removing
◆ Remove the chute as described above.
◆ Lock the blade disc using a block of wood (10)
as shown (fig. D3).
◆ Remove the blades (11) by loosening the Allen
screws (12) using the Allen key provided (fig. D4).
Refitting
To refit the blades:
◆ Place the blades on the disc with the ground
edge facing down. The holes in the blades
must line up with those in the disc.
◆ Securely fasten the blades (11) by tightening
the Allen screws (12).
◆ Remove the block of wood (10).
◆ Replace the chute (3) and tighten the thumb
nut (7) (fig. D1 & D2).
Restarting a clogged shredder
If the motor is overloaded, the tool will
automatically be switched off.
◆ Allow the motor to cool down for a few minutes.
If the motor still refuses to start:
◆ Make sure that the tool is switched off
and unplugged.
◆ Take care not to cut yourself. Preferably
wear gloves.
◆ Remove the chute as described above.
◆ Carefully remove all material from the shredder.
◆ Replace the chute as described above.
◆ Plug the tool in and switch it on.
ENGLISH
(96 páginas)
(12 páginas)
(84 páginas)
(12 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais